Mazda 0000-8F-N02B Bedienungshandbuch PDF herunterladen (Seite 10)

4280159 Rev. A 10/10

IGNITION SWITCH CONNECTOR

1. Route the remote start ignition harness with 6-pin male and fe-

male ignition connectors over the factory harness, along the

left side of the steering column. Do not secure harness at this

time.

CAUTION: EXTREME CARE MUST BE TAKEN TO ROUTE THE

REMOTE START HARNESS AWAY FROM THE

STEERING COLUMN ADJUSTER SPRING.

2. Locate the 6-pin WHITE ignition connector, on the left side of

the steering column.

3. Release the red secondary lock and disconnect the 6-pin WHITE

ignition connector by pulling outward. ( CAUTION: DO NOT

PULL ON WIRES TO DISCONNECT CONNECTOR.)

4. Plug the 6-pin female remote start harness connector into the

factory ignition switch and engage the red secondary lock.

(FIGURE W)

5. Plug the 6-pin male remote start harness connector into the 6-

pin female factory ignition connector and engage the red sec-

ondary lock. (FIGURE W)

WIRE HARNESS CONNECTIONS - STEERING COLUMN

PARKING LIGHT CONNECTION

1. Locate the 17-pin WHITE multifunction switch connector on the

left side of the steering column (plugged into the turn signal

assembly). (FIGURE X)

2. Using a razor knife carefully cut back 1”-2” of the electrical tape

to expose the wiring. ( CAUTION: BE EXTREMELY CARE-

FUL NOT TO DAMAGE ANY OF THE WIRES.)

3. Using (1) supplied IDC wire tap, connect the wires listed below

and crimp the IDC wire tap in place using pliers. Ensure that a

complete and secure connection is made. Refer to FIGURE X

& Y for proper connector and pin location.

FIGURE X

VIEW FROM HARNESS SIDE

FIGURE Y

FIGURE W

VEHICLE’S PARKING LIGHT WIRE REMOTE START HARNESS WIRE

BROWN (RETRACTABLE KEY) BROWN/WHITE

BROWN/WHITE (SMART-KEY) BROWN/WHITE

NOTE: Refer to Page 2 for IDC Wire Tap Procedure and Wire color code information.

6-pin female

6-pin male

17-pin

BR/W

: WITH SMART KEY

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 25 26

Kommentare zu diesen Handbüchern

Keine Kommentare

Mazda 0000-8F-N02B Bedienungshandbuch Seite 10

Kommentare zu diesen Handbüchern