Mazda 0000-8F-N02B Bedienungshandbuch Seite 5

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 26
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 4
5
4280159 Rev. A 10/10
REMOTE START CONTROL MODULE PREPARATION
1. Insert the supplied fuses into the remote start control module as shown below. (FIGURE F)
The fuses fit tightly, so use the flat tip of a fiber stick to push them in place, if necessary.
2. Install DNA card into the remote start control module as shown below. (FIGURE G)
CAUTION: Use care to assure that both rows of the multi-pin connector are aligned and
seated properly or the remote start system will NOT operate properly.
3. Plug the supplied wire harness 10-pin and 24-pin connectors into the remote start control mod-
ule. (FIGURE H) Make sure the connectors are seated completely. NOTE: The connectors will
only plug into the remote start control module one way.
4. Plug the supplied immobilizer interface 4-pin connector into the remote start control module.
(FIGURE H)
NOTE: TAPE OFF THE WHITE WIRE (IF EQUIPPED) COMING FROM THE 4-WAY
CONNECTOR (THIS WIRE IS NOT USED ON THIS SYSTEM).
2
FIGURE F
FIGURE G
REMOTE ENGINE START MODULE AND IMMOBILIZER INTERFACE MOUNTING
3
REMOTE ENGINE START MODULE MOUNTING
1. Locate the two large wire harnesses high up under the
dashboard running near the vehicle dashwall.
2. Using (3) supplied, long wire ties, secure the remote start
control module to the wire harnesses. (FIGURE I)
NOTE:EXTREME CARE MUST BE TAKEN TO ROUTE
THE REMOTE START WIRING HARNESS AWAY
FROM ANY EXISTING INSTALLED
ACCESSORIES.
IMMOBILIZER INTERFACE MODULE MOUNTING
1. Locate the large wire harness routed between the steer-
ing column and diagnostic connector. (FIGURE J)
2. Using (1) supplied, long wire tie, secure the immobilizer
interface to the wire harness. (FIGURE J)
Tie Wraps
5
15
15
15
15
15
15
5
15
15
15
15
15
15
-+
-+
15
HVAC 1
HVAC 2
MAIN B+
IGNITION
DOME LIGHT
PK LIGHTS
DOOR LOCKS
15
TRUNK RELEASE
FIGURE I
FIGURE H
!
4-pin
10-pin
24-pin
FIGURE J
Wire
Harness
Wire
Tie
Diagnostic
Connector
Remote Start
Wire Harness
Immobilizer
Wire Harness
Wire Tie
Wire Tie
Seitenansicht 4
1 2 3 4 5 6 7 8 9 10 ... 25 26

Kommentare zu diesen Handbüchern

Keine Kommentare