Mazda 0000-8F-N02B Bedienungshandbuch PDF herunterladen (Seite 8)

4280159 Rev. A 10/10

Hood Safety

Switch Wiring

Main Wire

Harness Grommet

HOOD SAFETY SWITCH MOUNTING, continued

4. Using fish wire, pull the hood safety switch wiring and WHITE/BLACK tach wire from the re-

mote start harness through the main wire harness grommet:

a. From inside of the vehicle, bend approximately three (3) inches of tach wire at wire end.

b. Using electrical tape, secure fish wire to tach wire as shown. (FIGURE S)

c. Insert the fish wire along with tach wire through the main wire harness grommet into the

engine compartment. (FIGURE T & U)

CAUTION: Do not pierce the main wire harness with fish wire when pulling through

main grommet.

d. Disconnect tach wire from fish wire and pull remaining slack of tach wire from the inside

of the vehicle out into the engine compartment.

e. Bend approximately three (3) inches of hood safety switch wiring at wire end.

f. Using electrical tape, secure fish wire to hood safety switch wiring as shown.

(FIGURE S)

g. Pull fish wire and hood safety switch wiring back through main wire harness grommet

into the vehicle. (FIGURE T & U)

h. Disconnect hood safety switch wiring from fish wire and pull remaining slack of hood

safety switch wiring from the engine compartment into the vehicle.

NOTE: Ensure the tach wire does not get pulled back into the vehicle.

FIGURE S

FIGURE T

Main Wire

Harness Grommet

Hood Safety

Switch Wiring

FIGURE U

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 25 26

Keine Kommentare

Mazda 0000-8F-N02B Bedienungshandbuch Seite 8