Mazda 2005 Miata MX-5 Spezifikationen PDF herunterladen (Seite 28)

Black plate (28,1)

Installing a Child-

Restraint System

The passenger lap/shoulder belt can easily

be converted into the automatic locking

mode, which must be done to hold the

child-restraint system.

Some child-restraint systems also employ

specially designed LATCH attachments;

refer to “LATCH Child-Restraint

Systems” (page 2-18).

Follow these manufacturer's instructions

when installing a child-restraint system on

the passenger's seat, unless you are

attaching a LATCH-equipped child-

restraint system to the LATCH lower

anchors. Refer to “LATCH Child-

Restraint Systems” (page 2-18).

NOTE

Follow the child-res traint system

manufacturer's instructions carefully. If

you are not sure whether you have a

LATCH system, check in the child-

restraint system manufacturer's

instructions and follow them

accordingly. Depending on the type of

child-restraint system, it may not

employ seat belts which are in

automatic locking mode, however if it

uses an upper tether, it cannot be

mounted properly in this vehicle as

there is no safe way to anchor the tether.

Before installing a rear-facing child-

restraint system, the passenger air bag

must be deactivated (page 2-23).

NOTE

Before installing a child-restraint

system, refer to “Passenger Air Bag

Deactivation Switch” (page 2-23).

1. Make sure to remove articles from

behind the passenger seat that would

prevent the seat from sliding back fully,

and then slide the seat as far back as

possible.

2. Secure the child-restraint system with

the lap portion of the lap/shoulder belt.

See the instructions on the child-

restraint system for belt routing

instructions.

3. To get the retractor into the automatic

locking mode, pull the shoulder belt

portion of the seat belt until the entire

length of the belt is out of the retractor.

4. Push the child-restraint system firmly

into the vehicle seat. Be sure the belt

retracts as snugly as possible. Clicking

from the retractor will be heard during

retraction if the system is in automatic

locking mode. If the belt does not lock

the seat down tight, repeat this step.

2-16

Essential Safety Equipment

Child Restraint

MX-5 Miata_8T72-EA-04G_Edition1 Page28

Wednesday, June 9 2004 3:4 PM

Form No.8T72-EA-04G

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 295 296

Kommentare zu diesen Handbüchern

Keine Kommentare