Mazda 2010 Mazda5 Spezifikationen PDF herunterladen (Seite 139)

Black plate (139,1)

When changing tires yourself

If you or someone else changes tires, you

or someone else can also undertake the

steps for the TPMS to complete the ID

signal code registration.

1. After tires have been changed, turn the

ignition switch to the ON position, then

turn it back to the ACC or LOC K

position.

2. Wait for about 15 minutes.

3. After about 15 minutes, drive the

vehicle at a speed of at least 25 km/h

(16 mph) for 10 min utes and the tire

pressure sensor ID signal code will be

registered automatically.

NOTE

If the vehicle is driven within about 15 minutes

of changing tires, the tire pressure monitoring

system warning light will flash because the

sensor ID signal code would not have been

registered. If this happens, park the vehicle for

about 15 minutes, after which the sensor ID

signal code will register upon driving the

vehicle for 10 minutes.

Replacing tires and wheels

CAUTION

Ø When replacing/repairing the tires

or wheels or both, have the work

done by an Authorized Mazda

Dealer, or the tire pressure sensors

may be damaged.

Ø The wheels equipped on your

Mazda are specially designed for

installation of the tire pressure

sensors. Do not use non-genuine

wheels, otherwise it may not be

possible to install the tire pressure

sensors.

Be sure to have the tire pressure sensors

installed whenever tires or wheels are

replaced.

When having a tire or wheel or both

replaced, the following types of tire

pressure sensor installations are possible.

l

The tire pressure sensor is removed

from the old wheel and installed to the

new one.

l

The same tire pressure sensor is used

with the same wheel. Only the tire is

replaced.

l

A new tire pressure sensor is installed

to a new wheel.

NOTE

l

The tire pressure sensor ID signal code

must be registered when a new tire pressure

sensor is purchased. For purchase of a tire

pressure sensor and registration of the tire

pressure sensor ID signal code, consult an

Authorized Mazda Dealer.

l

When reinstalling a previously removed tire

pressure sensor to a wheel, replace the

grommet (seal between valve body/sensor

and wheel) for the tire pressure sensor.

Driving Your Mazda

Starting and Driving

5-31

Mazda5_8AU7-EA-09H_Edition1 Page139

Wednesday, July 8 2009 11:27 AM

Form No.8AU7-EA-09H

1 2 ... 134 135 136 137 138 139 140 141 142 143 144 ... 387 388

Kommentare zu diesen Handbüchern

Keine Kommentare