Mazda 2012 CX-7 Spezifikationen PDF herunterladen (Seite 179)

Black plate (179,1)

NOTE

If the HomeLink indicator light does not

change to a rapidly blinking light, contact

HomeLink at www.homelink.com or call 1-

800-355-3515 for assistance.

4. Firmly press and hold the progra mmed

HomeLink button for five seconds, and

then release it. Perform this operation

two times to activate the door. If the

door does not activate, press and hold

the just-trained HomeLink button and

observe the indicator light.

If the indicator light stays on constantly,

programming is complete and your

device should activate when the

HomeLink button is pressed and released.

NOTE

To program the remaining two HomeLink

buttons, begin with “Programming” ― step 1.

If the indicator light blinks rapidly for

two seconds and then turns to a

constant light, continue with

“Programming” steps 5―7 to complete

the programming of a rolling code

equipped device (most commonly a

garage door opener).

5. At the garage door opener receiver

(motor-head unit ) in the garage, locate

the “learn” or “smart” button. This can

usually be found where the hanging

antenna wire is attached to the motor-

head unit.

6. Firmly press and release the “ learn” or

“smart” button. (The name and color of

the button may vary by manufacturer.)

NOTE

There are 30 seconds in which to initiate step

7.

7. Return to the vehicle and firmly press,

hold for two seconds and release the

programmed HomeLink button. Repeat

the “press/hold/release” sequence a

second time, and, depending on the

brand of the garage door opener (or

other rolling code equipped device),

repeat this sequence a third time to

complete the progra mming process.

HomeLink should now activate your

rolling code equipped device.

NOTE

To program the remaining two HomeLink

buttons, begin with “Programming” ― step 1.

For questions or comments, please contact

HomeLink at www.homelink.com or 1-

800-355-3515.

qGate operator/Canadian

Programming

Canadian radio-frequency laws require

transmitter signals to “time-out” (or quit)

after several seconds of transmission ―

which may not be long enough for

HomeLink to pick up the signal during

programming. Similar to this Canadian

law, some U.S. gate operators are

designed to “time-out” in the same

manner.

If you live in Canada or you are having

difficulties programming a gate operator

by using the “Programming” procedures

(regardless of where you live), replace

“Programming HomeLink” step 2 with

the following:

NOTE

If programming a garage door opener or gate

operator, it is advised to unplug the device

during the “cycling” process to prevent

possible overheating.

When Driving

Switches and Controls

4-55

CX-5_8CA5-EA-11L_Edition3 Page179

Friday, June 22 2012 3:45 PM

Form No.8CA5-EA-11L

1 2 ... 174 175 176 177 178 179 180 181 182 183 184 ... 487 488

Kommentare zu diesen Handbüchern

Keine Kommentare