Powertrain Engines
• When replacing the timing belt, the timing belt tensioner has to be checked as following
(refer to the workshop manual for details):
– Measure the tensioner rod projection length.
– Inspect the tensioner for oil leakage.
– Verify the thrust/resistance of the tensioner.
NOTE: If the tensioner rod projection length and/or tensioner thrust/resistance exceeds the
specification and/or there is an oil leakage, replace the timing belt tensioner.
• Before installing the timing belt tensioner, the tensioner rod has to be pushed down and
secured by inserting a locking pin with 1.5 mm diameter (refer to the workshop manual
for details).
NOTE: Placing the timing belt tensioner horizontally while pushing the tensioner rod can
cause oil leakage and damage the automatic tensioner.
NOTE: To prevent damage to the timing belt tensioner, the tensioner rod has to be pushed
slowly with a force not greater than the specified 235 N. The tensioner rod must not
touch the bottom.
L1001.4_01067
1 Tensioner rod 3 Locking pin
2 Tensioner rod projection length
Curriculum Training 01-69
Kommentare zu diesen Handbüchern