MECHANICAL
01–10–37
01–10
Engine Workshop Manual 13B-MSP (Multi Side Port) (1773–1U–03C)
Revised 6/2008 (Ref. No. R108/08)
Rotor Housing Assembly Note
Caution
• Assemble the seal rubber without any torsion.
• Do not get oil or grease on the seal rubber.
1. Apply petroleum jelly to a new seal rubber.
2. Assemble the outer seal rubber to the housing
with the white paint in the direction shown in the
figure.
3. Assemble the inner seal rubber to the housing
with the seal rubber joint placed between A—B.
4. Apply the silicone sealant to the position indicated
in the figure.
Bead thickness
2.5—6.5 mm {0.099—0.255 in}
5. Apply thread locking compound to the attaching
surface of the apex seal and the side piece and
affix them.
Caution
• After adhesion, make sure that there is
no gap between the apex seal and side
piece.
WHITE PAINT
HOUSING
CHU0110E061
B
A
CHU0110E062
8—12 mm
{0.32—0.47 in}
SEAL RUBBER
GROOVE
CHU0110E033
ATTACHING SURFACE
CHU0110E059
Kommentare zu diesen Handbüchern