Mazda LF Spezifikationen PDF herunterladen (Seite 17)

MECHANICAL

01–10–3

01–10

ENGINE MOUNTING/DISMOUNTING

E5U011002000E02

1. Install the SSTs (arms) to the cylinder block holes

as shown, and hand-tighten the bolts (part No.:

9YA20-1003) or M10 × 1.5T length 90 mm {3.55

in}.

2. Assemble the SSTs (bolts, nuts and plate) to the

specified positions.

3. Adjust the SSTs (bolts) so that less than 20 mm

{0.79 in} of thread is exposed.

4. Make the SSTs (arms and plate) parallel by

adjusting the SSTs (bolts and nuts).

5. Tighten the SSTs (bolts and nuts) to affix the

SSTs firmly.

Warning

• Self-locking brake system of the engine

stand may not be effective when the

engine is held in an unbalanced position.

This could lead to sudden, rapid

movement of the engine and mounting

stand handle and cause serious injury.

Never keep the engine in an unbalanced

position, and always hold the rotating

handle firmly when turning the engine.

6. Mount the engine on the SST (engine stand).

7. Drain the engine oil into a container.

8. Install the oil pan drain plug.

• With washer

1. Install the oil pan drain plug with a new washer.

Tightening torque

30—41 N·m {3.1—4.1 kgf·m, 23—30 ft·lbf}

• Without washer

1. Inspect the seal rubber of the oil pan drain plug and make sure there are no cracks or damage.

— If necessary, replace the oil pan drain plug.

2. Clean the flange surface (seal rubber) on the oil pan drain plug, then install the oil pan drain plug.

Tightening torque

22—30 N·m {2.2—3.1 kgf·m, 16—22 ft·lbf}

DISMOUNTING

• Dismount in the reverse order of mounting.

End Of Sie

49 L010 102

B3E0110W127

49 L010 101

49 L010 104

49 L010 105

C3U0110E001

49 L010 101

49 L010 102

49 L010 104

49 L010 103

49 L010 105

PARALLEL

APPROX. 20 mm {0.79 in}

ENGINE

BOLT

E5U110ZW8S01

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare

Mazda LF Spezifikationen Seite 17

Kommentare zu diesen Handbüchern