Mazda LF Spezifikationen Seite 31

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 60
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 30
MECHANICAL
01–10–17
01–10
TAPPET INSPECTION
E5U011012431E01
1. Measure the tappet hole inner diameter in X and
Y directions at the two points (A and B) shown in
the figure.
Tappet bore diameter (Standard)
31.000—31.030 mm {1.2205—1.2216 in}
2. Measure the tappet body outer diameter in X and
Y directions at the two points (A and B) shown in
the figure.
Tappet diameter (Standard)
30.970—30.980 mm {1.2193—1.2196 in}
3. Subtract the tappet body outer diameter from the
tappet hole inner diameter.
If it exceeds the specification, replace the
tappet or cylinder head.
Tappet-to-Tappet bore oil clearance (Standard)
0.02—0.06 mm {0.0008—0.0023 in}
Tappet-to-Tappet bore oil clearance (Maximum)
0.15 mm {0.006 in}
End Of Sie
CYLINDER BLOCK INSPECTION
E5U011010300E01
1. Measure the distortion of the cylinder block top
surface in six directions as indicated in the figure.
If it exceeds the maximum, replace the
cylinder block.
Cylinder head gasket contact surfaces
distortion (Maximum)
0.10 mm {0.004 in}
2. Measure the cylinder bores in X and Y directions
at 42 mm {1.65 in} below the top surface.
If not within the specification, replace the
cylinder block.
Cylinder bore diameter (Standard)
87.500—87.530 mm {3.4449—3.4460 in}
Minimum / maximum bore diameter limit
87.440—87.590 mm {3.4425—3.4484 in}
End Of Sie
X
Y
A
B
ADJ2224E023
A
B
Y
X
ADJ2224E029
ADJ2224E089
42 mm {1.65 in}
X
Y
C3U0110E007
Seitenansicht 30
1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare