11
1. Install the hood switch to the hood latch and secure it using a
screw (1 location).
2. Hook the hood switch harness to the hood latch and secure it
using a tie wrap (Black) at one location.
3. Install tie wraps (Black) to the mount bases and temporarily
tighten the hood switch harness at two locations.
4. Peel back the tape backings on the back of the mount bases
and affix the mount bases on the shroud member upper at two
locations with the hood switch harness routed as shown in the
figure.
5. Pass the hood switch harness between the grille bracket and
the shroud member upper.
6. HOOD SWITCH INSTALLATION
This procedure is not necessary for vehicles with the theft deterrent or with i-ELOOP system
because the hood switch is already installed.
Do not tighten the tie wrap (Black) so much that the hood
switch harness cannot move.
Mount base and
Tie wrap (Black)
Mount base and
Tie wrap (Black)
Do no let hood switch
harness contacts bolt.
Place the tightening part of the tie wrap (Black) downward
and secure. Otherwise, it may not be possible to re-install
the seat plate.
Kommentare zu diesen Handbüchern