6
Negative battery cable disconnection
1. Set the selector lever to P range.
2. Disconnect the negative battery cable and wrap tape around it
to insulate.
Tightening torque : 4.0 - 6.0 N・m
■Parts ① to ④ are only for vehicles without theft-
deterrent or without i-ELOOP system
① Seat plate removal
1. Remove the fasteners (2 locations).
2. Lift up the seat plate in the direction of the arrow to detach the
guides (3 locations), and remove the seat plate.
② Hood latch protector removal
1. Insert a tape-wrapped flathead screwdriver into the position
shown in the figure.
2. Move the tape-wrapped flathead screwdriver in the direction of
arrow (1) shown in the figure to press the hood latch protector
tab, and lift the tab up in the direction of arrow (2) and detach
its tab from the hood latch.
3. Detach all the hood latch protector tabs from the hood latch
and remove the hood latch protector.
When the negative battery cable is connected during
operation, it may cause electric shock or other personal
injuries. Disconnect the negative battery cable before
removal/installation.
Be careful not to damage or lose any parts removed from the vehicle since they will be reused.
: Flathead screwdriver insertion slot
Kommentare zu diesen Handbüchern