Mazda GENUINE C930 V7 620 Bedienerhandbuch Seite 20

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 33
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 19
20
9-3. Warm up time check
This operation only applies when the engine has been started with the remote
control.
z Press the function switch once.
The LCD display will appear as
shown on the right.
z Press the start switch while the
above LCD display is shown until it
beeps.
After the send mark flashes, the
send operation is completed. After
the send operation is completed,
the controller will send an answer
back signal.
*Press the start switch within 2 seconds after the LCD display appears. If the
start switch is not pressed in time and the LCD display disappears, start the
procedure over again from step 1.
When the remote control receives a
response from the vehicle, it indicates
the engine start operation with the
display below and a melody.
Warm up time remaining?
(It only displays even numbers.)
Is the engine running?
Is the rear defrost turned on?
The LCD display will appear when the
switch is released.
ADVICE
Function switch
While LCD
dis
p
la
y
s
Start switch
Display Example
8 min. warm up time remaining
Engine running
Rear defrost stopped
Seitenansicht 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 32 33

Kommentare zu diesen Handbüchern

Keine Kommentare