If the following problem or error occurs with the aforementioned Genuine Remote Engine Start (hereafter referred to as "RES"), use
NOYESNOYESNOYESNOYESWhile the turn signal lamp is flashing(activated by the vehicle's turn signalswitch), the hazard lights cannot be turnedon wi
*Harness kit includedNOYESNOYESNOYESNOYESNOYESNOYESNOYESNOYESNOYES NOYESNOYESNOYESNOYESWhen connecting to the vehicle battery, the controllerbuzzer be
*Manuals provided to authorized Mazda dealersNOYESNOYESNOYESNOYESCheck the wiring (Refer to ).When performing the remote control operations,
*Spare remote control (Part No.: C930 V7 621) includedNOYESNOYESNOYESNOYESNOYESNOYESNOYESNOYESNOYES NOYESNO*Manuals provided to authorized Mazda deale
*Spare remote control (Part No.: C920 V7 620) includedNOYESNOYESNOYESNOYESCheck the wiring (Refer to ).Registration Procedure in manualAfter
NOYESNOYESNOYESNO(Spare remote control) Part No.: C930 V7 621YESNO(Spare remote control) Part No.: C930 V7 621YESInsert the batteries correctly.If the
Note: When using a tester to check, refer to the circuit diagram in the next page and the User's instructions.When using the tester, make contact
䋼㪚㫀㫉㪺㫌㫀㫋㩷㪻㫀㪸㪾㫉㪸㫄䋾㪝㫀㪾㪅㩷㪚㫆㫅㫅㪼㪺㫋㫆㫉㫊㩷㫍㫀㪼㫎㪼㪻㩷㪽㫉㫆㫄㩷㪿㪸㫉㫅㪼㫊㫊㩷㫊㫀㪻㪼㪚㫆㫅㫅㪼㪺㫋㫆㫉㪲㪈㪴㩷䋺㩷㪝㪼㫄㪸㫃㪼㩷㪈㪉㫇㫀㫅㫊㪚㫆㫅㫅㪼㪺㫋㫆㫉㪲㪉㪴㩷䋺㩷㪝㪼㫄㪸㫃㪼㩷㪉㫇㫀㫅㫊To the ground on the vehicle's bo
Put the shift lever in the “P” position.There is an advanced key (orsmart key) inside the vehiclecabin.Close all doors (including the rear gate) all t
YESNOYESNOYESCheck the wiring (Refer to ).The error display "Er" appears on LCDmonitor for the remote control.Even when operating
NOYESNOYESNOYESNO YESNOYESNOYESRefer to the basic operation items in the "User'sinstructions" to perform the remote control operationco
The controller buzzer sounds and the engine stops after starting the engine with the remote control.3 times3 times 5 timesA door is openCAN communicat
*Manuals provided to authorized Mazda dealersTroubleshooting ProcedureSSU conditions NG5 times• Perform steps 2 through 5 in the manual's registr
*Spare remote control (Part No.: C930 V7 621) included• Perform steps 3 to 7 in the manual's registration procedure withinthe prescribed time per
NOYES YES NO*Spare remote control (Part No.: C930 V7 621) includedNOYESNOYESNOYESNOYESNOYES NO YESNOYESNOYESNOYESWhen the light switch is set to the &
NOYESNOYESNOYESNOYESRepair the problem area.Refer to , and follow thetroubleshooting procedure for the errordisplay that appears.Check the
NOYESNOYESNOYESNOYESNOYESIf the engine is started using anothermethod (such as the vehicle's push startswitch) other than the Remote Engine Start
NOYESNOYESNOYESNOYESNOYESNOYESNOYESIf the engine is started using another method (such as thevehicle's push start switch) other than the Remote E
NOYESNOYESOnce the engine is started up normally using the "Engine startoperation," the rear defrost cannot be forced on.To turn on, first,
NOYESNOYESNOYESSet the warm up time again. If the time stilldoes not set, the remote control is defectiveor faulty. Replace the remote control.Repair
NOYESNOYESNOYESNOYESNOYESNOYESNO NOYES YESEven if the rear defrost operation isexecuted on the remote control, the displaylamp for the rear defrost o
Kommentare zu diesen Handbüchern