NO
YES
NO
YES
NO
YES
NO
(Spare remote control) Part No.: C930 V7 621
YES
NO
(Spare remote control) Part No.: C930 V7 621
YES
Insert the batteries correctly.
If there is a mark, replace the remote control
batteries with new ones (CR2032 × Qty.2).
If the problem still does not improve, the remote
control is defective or faulty. Replace the remote
control.
When performing the following remote control operation, the
vehicle mark displays on the LCD monitor.
When performing an "Engine
stop operation"
When performing an "Engine
start operation"
Remote control operation check
Are the remote control batteries correctly inserted?
(Refer to the "User's instructions")
When performing the "Vehicle status check"
operation on the remote control, the "Battery mark"
does not light up on the upper right hand corner of
the LCD monitor.
To prevent the vehicle from accidentally moving due t
remote control operation, first, disconnect the minus terminal
on the vehicle battery and then perform the follow diagnostics
check.
When performing the "Vehicle status check"
operation on the remote control, the "Send error
mark (BUSY)" does not light up on the upper right
hand corner of the LCD monitor.
When performing the following remote control operations, a
"Receive error (Er)" displays on the LCD monitor as answer
back si
nal and the buzzer bee
short bee
.
There is no problem with the remote control
operation.
Reconnect the minus terminal on the vehicle battery.
Return to the previous page and finish conducting the
diagnostics check.
ޓޓޓWhen pressing the switch
When performing a "Car find"
operation
When the battery power is almost completely
gone, the "Battery mark" will not light up.
Replace the remote control batteries with new
ones (CR2032 × Qty.2), and perform a remote
control operation check again.
If these steps do not improve its condition, the
remote control is faulty or defective. Replace the
remote control.
If there is a mark, the send operation from the
remote control is restricted due to the transmission
conditions in the area.
Wait until the display mark turns off before
performing the "Vehicle status check" again on the
remote control.
When the battery power is almost completely
gone, the "Battery mark" will not light up.
Replace the remote control batteries with new
ones (CR2032 × Qty.2), and perform a remote
control operation check again.
If these steps do not help improve or solve the
problem, the remote control is faulty or defective.
Replace the remote control.
B1
This mark does not light up.
This mark does not light up.
㪈㪌
(17 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern