Mazda 2005 RX-8 Spezifikationen PDF herunterladen (Seite 154)

Black plate (154,1)

qProgramming the HomeLink

System

CAUTION

When programming a garage door

opener or a gate, disconnect the power

to these devices before performing

programming, as continuous operation

of the devices could damage the motor.

The Hom eLink system provides 3 buttons

which can be individually selected and

programmed using the transmitters for

current, on-market devices as follows:

1. Press and hold the two outer

HomeLink buttons (buttons one and

three) - releasing only when the

indicator light begins to flash (after 20

seconds). Do not hold the buttons for

longer than 30 seconds and do not

repeat step 1 to program a second and/

or third hand-held transmitter to the

remaining two HomeLink buttons.

2. Position the end of your hand-he ld

transmitter 2.5―7.5 cm (1―3 inches)

away from the HomeLink button you

wish to program while keeping the

indicator light in view.

3. Simultaneously press and hold both the

chosen HomeLink and hand-held

transmitter buttons. Do not release the

buttons until step 4 has been

completed.

NOTE

Some gate operators and garage door

openers may require you to replace this

Programming Step 3 with procedures

noted in the “Gate Operator/Canadian

Programming” section.

4. After the HomeLink indicator light

changes from a slow to a rapidly

blinking light, release both the

HomeLink and hand-held transmitter

buttons.

NOTE

If the HomeLink indicator light does

not change to a rapidly blinking light,

contact HomeLink at

www.homelink.com or call 1-800-355-

3515 for assistance.

5. Press and hold the just-trained

HomeLink button and observe the

indicator light.

If the indicator light stays on constantly,

programming is complete and your

device should activate when the

HomeLink button is pressed and released.

NOTE

To program the remaining two

HomeLink buttons, begin with

“Programming” - step 2. Do not repeat

step 1.

If the indicator light blinks rapidly for

two seconds and then turns to a

constant light, continue with

“Programming” steps 6―8 to complete

the programming of a rolling code

equipped device (most commonly a

garage door opener).

6. At the garage door opener receiver

(motor-head unit ) in the garage, locate

the “learn” or “smart” button. This can

usually be found where the hanging

antenna wire is attached to the motor-

head unit.

5-58

Driving Your Mazda

Switches and Controls

RX-8_8T69-EA-04G_Edition1 Page154

Wednesday, June 9 2004 2:12 PM

Form No.8T69-EA-04G

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 363 364

Kommentare zu diesen Handbüchern

Keine Kommentare