Mazda 2006 MX-5 Spezifikationen PDF herunterladen (Seite 240)

Black plate (240,1)

NOTE

l

Check the tire inflation pressure label

(driver's door frame) for the correct

tire inflation pressure.

l

Do not use the compressor for longer

than 10 minutes because using the

compressor for long periods could

damage it.

l

If the tire does not inflate, repair of

the tire may not be possible. If the

tire does not reach the correct

inflation pressure within a 10-minute

period, it probably has received more

extensive damage. When this

happens, the emergency flat tire

repair kit cannot be used to repair the

tire. Contact an Authorized Mazda

Dealer.

l

If the tire has been over-inflated,

loosen the screw cap on the

compressor and bleed some of the air

out.

17. When the tire has been inflated to the

proper inflation press ure, turn the

compressor switch off and remove the

compressor hose from the tire valve.

18. Install the tire valve cap.

19. Put the emergency flat tire repair kit

in the trunk and continue driving.

CAUTION

l

Drive carefully to an Authorized

Mazda Dealer and keep the vehicle

speed below 80 km/h (50 mph).

l

If the vehicle is driven 80 km/h (50

mph) or higher, the vehicle might

begin to vibrate.

20. After driving the vehicle for 10

minutes or 5 km (3 miles), check the

tire pressure with the tire pressure

gauge equipped with the compressor.

If the tire pressure has fallen below

the correct tire pressure, inflate the

tire to the correct pressure again

following the steps from number 15.

CAUTION

l

If the tire inflation pressure falls

below 130 kPa (1.3 kgf/cm

2

or bar,

18.9 psi), repair cannot be done with

the repair kit. Park the vehicle on a

level surface off the right-of-way and

contact an Authori zed Mazda Dealer.

l

If the tire inflation pressure

continues to remain low after

repeating steps 14 to 21, park the

vehicle on a level surface off the

right-of-way and contact an

Authorized Mazda Dealer.

NOTE

When checking the tire inflation

pressure with the tire pressure gauge on

the compressor unit, make sure the

compressor switch is turned off.

21. If the tire inflation pressure remains

stable, the tire repair is complete.

Drive the vehicle with care to an

Authorized Mazda Dealer to have the

tire replaced.

7-12

In Case of an Emergency

Flat Tire

MX-5_8U35-EA-05F_Edition1 Page240

Monday, April 18 2005 4:19 PM

Form No.8U35-EA-05F

1 2 ... 235 236 237 238 239 240 241 242 243 244 245 ... 365 366

Kommentare zu diesen Handbüchern

Keine Kommentare