Mazda Remote Start System Installationshandbuch Seite 6

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 7
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 5
6 | P a g e
Method 2 – Wrap and tape
This is the most popular method and is also very reliable. Strip back a section of the insulation on the wire in the car.
On heavy gauge wires, 1” is about the right amount. On lighter gauge wires, ½” is fine. Strip 1” of insulation off the end
of the remote start wire. Separate the strands of the wire like this:
Pass the wire from the remote through the opening as shown below
Wrap the remote start wire around both sides of the car wire, then back around itself as shown below
Use electrical tape to wrap the connection and secure the wires together. A wire tie will help prevent the tape from
unraveling in the future.
Method #3 – “T-Taps”
T-taps are plastic clips that are squeezed onto the wires in the car. The wire from the remote start goes into the tap
and the whole thing is crimped together. T-taps come in different sizes for different size wires. Use yellow t-taps for
the larger wires in your main power harness. Red t-taps are good for the smaller wires. Tape and wire tie the
connections as shown in the “wrap and tape” section above – that will prevent the t-taps from ever opening up.
Using T-Taps
Use a pair of pliers to attach the quick-connects to the wires in your car. Hold the quick connect as shown below in
Figure 1, then clamp it on to the wire as shown in Figure 2. There is a locking tab at the front of the connector (Figure 3)
– make sure it is secure and locked in place when you are done.
Figure 1
Figure 2
Figure 3
Seitenansicht 5
1 2 3 4 5 6 7

Kommentare zu diesen Handbüchern

Keine Kommentare