Mazda 2002 B2300 Spezifikationen PDF herunterladen (Seite 114)

WARNING: The lap belts should fit snugly and as low as possible

around the hips, not around the waist. Failure to position the lap

belt correctly may cause serious injury in an accident.

If you need to lengthen the belt, unfasten it and repeat the procedure

above.

To unfasten the belt, push in the release button prior to opening the rear

door.

Safety belt extension assembly

If the safety belt assembly is too short for you, even when fully

extended, 20 cm (8 inches) can be added to the safety belt assembly by

adding a safety belt extension assembly. Safety belt extension assemblies

can be obtained from your authorized Mazda dealership.

Use only extensions manufactured by the same supplier as the safety

belt. Manufacturer identification is located at the end of the webbing on

the label. Also, use the safety belt extension only if the safety belt is too

short for you when fully extended.

NOTE:Do not use extensions to change the fit of the shoulder belt

across the torso.

Safety belt warning light and indicator chime

The seat belt warning light illuminates in the instrument cluster and a

chime sounds to remind the occupants to fasten their safety belts.

Conditions of operation

If... Then...

The driver’s safety belt is not

buckled before the ignition switch

is turned to the ON position...

The safety belt warning light

illuminates 1-2 minutes and the

warning chime sounds 4-8

seconds.

The driver’s safety belt is buckled

while the indicator light is

illuminated and the warning chime

is sounding...

The safety belt warning light and

warning chime turn off.

The driver’s safety belt is buckled

before the ignition switch is turned

to the ON position...

The safety belt warning light and

indicator chime remain off.

Seating and Safety Restraints

114

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 287 288

Keine Kommentare

Mazda 2002 B2300 Spezifikationen Seite 114