Mazda 2002 B2300 Spezifikationen PDF herunterladen (Seite 78)

To install the new bulb:

Handle a halogen headlamp bulb carefully and keep out of

children’s reach. Grasp the bulb only by its plastic base and do

not touch the glass. The oil from your hands could cause the bulb

to break the next time the headlamps are operated.

NOTE: If the bulb is accidentally touched, it should be cleaned with

rubbing alcohol before being used.

1. With the flat side of the bulb’s plastic base facing upward, insert the

glass end of the bulb into the lamp assembly. You may need to turn

the bulb left or right to align the grooves in the plastic base with the

tabs in the lamp assembly. When the grooves are aligned, push the

bulb into the lamp assembly until the plastic base contacts the rear

of the lamp assembly.

2. Install the bulb retaining ring over the plastic base until it contacts

the rear of the socket by rotating clockwise until you feel a “stop.”

3. Install the electrical connector into the plastic base until it snaps,

locking it into position.

4. Install the headlamp on vehicle, push rearward and secure with two

retainer pins.

5. Turn the headlamps on and make sure they work properly. If the

headlamp was correctly aligned before you changed the bulb, you

should not need to align it again.

Replacing front side marker bulbs

1. Open the hood.

2. At the back of the headlamp,

pry up the two retainer pins to

release the headlamp assembly

from the vehicle and pull

headlamp forward.

Lights

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 287 288

Keine Kommentare

Mazda 2002 B2300 Spezifikationen Seite 78