Mazda 2012 CX5 Spezifikationen PDF herunterladen (Seite 166)

Black plate (166,1)

Adjust the tire pressure to the correct tire

pressure and initialize TPMS. Refer to the

specification charts (page 9-8).

NOTE

l

Perform tire pressure adjustment when the

tires are cold. Tire pressure will vary

according to the tire temperature, therefore

let the vehicle stand for 1 hour or only drive

it 1.6 km (1 mile) or less before adjusting

the tire pressures. When pressure is

adjusted on hot tires to the cold inflation

pressure, the TPMS warning light/beep may

turn on after the tires cool and pressure

drops below specification.

Also, an illuminated TPMS warning light,

resulting from the tire air pressure dropping

due to cold ambient temperature will

remain illuminated even if the ambient

temperature rises. In this case, it will also

be necessary to adjust the tire air pressures.

If the TPMS warning light illuminates due

to a drop in tire air pressure, make sure to

check and adjust the tire air pressures.

l

Tires lose air naturally over time and the

TPMS cannot tell if the tires are getting too

soft over time or you have a flat. However,

when you find one low tire in a set of four-

that is an indication of trouble; you should

have someone drive the vehicle slowly

forward so you can inspect any low tire for

cuts and any metal objects sticking through

tread or sidewall. Put a few drops of water

in the valve stem to see if it bubbles

indicating a bad valve. Leaks need to be

addressed by more than simply reinflating

the tire as leaks are dangerous - take it to

an Authorized Mazda Dealer.

If the warning light illuminates again even

after the tire pressures are adjusted and the

TPMS initialization is performed, there

may be a tire punctu re. Replace the

punctured tire with the temporary spare

tire (page 7-7).

Warning light flashes

If the tire pressure monitoring system has

a malfunction, the tire pressure warning

light flashes for about 1 minute when the

ignition is switched ON and then

continues illuminating. Have your vehicle

checked by an Authorized Mazda Dealer

as soon as possible.

qKEY Warning Light (Red)/KEY

Indicator Light (Green)

Type A

“Keyless System Inspection Required”

is displayed

This message is displayed if the advanced

keyless entry & push button start system

has a problem.

Contact an Authorized Mazda Dealer.

CAUTION

If the above message is indicated, or

the push button start indicator light

(amber) flashes, the engine may not

start. If the engine cannot be started,

try starting it using the emergency

operation for starting the engine, and

have the vehicle inspected at an

Authorized Mazda Dealer as soon as

possible.

Refer to Emergency Operation for

Starting the Engine on page 4-8.

4-38

When Driving

Instrument Cluster and Display

CX-5_8CT5-EA-12K_Edition1 Page166

Friday, October 19 2012 3:10 PM

Form No.8CT5-EA-12K

1 2 ... 161 162 163 164 165 166 167 168 169 170 171 ... 527 528

Kommentare zu diesen Handbüchern

Keine Kommentare