Mazda 2014 2 Spezifikationen PDF herunterladen (Seite 469)

100

101

Black plate (469,1)

WARNING

Attach the speed restriction sticker in a

place where it can be viewed easily by

the driver:

Ø Applying the speed restriction

sticker to the steering wheel is

dangerous as it could interfere

with the air bag deployment and

result in serious injury.

Ø Do not apply the sticker to any

position other than the position

indicated in the illustration of the

speedometer.

10. Switch the ignition ON (engine

running).

11. Turn the compressor on and wait until

the sealant is injected into the tire.

After the sealant is injected into the

tire, continue waiting until the tire is

inflated to the correct air pressure.

NOTE

Check the tire inflation pressure label

(driver's door frame) for the correct tire

inflation pressure.

If the tire air pressure is not correct after a

few seconds, the tire may be seriously

damaged. Consult an Authorized Mazda

Dealer.

12. When the tire has been inflated to the

proper inflation press ure, turn the

compressor switch off and remove the

hose from the tire valve.

13. Install the tir e valve cap.

14. Store the hose, removed from the

valve, in the trunk and resume driving

the vehicle.

CAUTION

Ø Drive carefully to an Authorized

Mazda Dealer and keep the

vehicle speed below 80 km/h (50

mph).

Ø If the vehicle is driven over 80

km/h (50 mph), the vehicle might

begin to vibrate.

NOTE

If the tire is not properly inflated, the tire

pressure monitoring system warning light

will illuminate (page 4-23).

Do not press the tire pressure monitoring

system set switch after installing the spare

tire or after using the emergency flat tire

repair kit. The switch is only to be pressed

after installing the repaired flat tire or

installing a replacement tire (page 4-23).

15. After driving the vehicle 5 km, set up

the compressor again using Step 8 of

the procedure. Turn the compressor

on and then off after a few seconds,

and check the tire air pressure. If the

tire air pressure is low, turn the

compressor on again and wait until

the tire inflates to the correct air

pressure.

CAUTION

Ø If the tire inflation pressure falls

below 130 kPa (1.3 kgf/cm

or bar,

18.9 psi), repair cannot be done

with the repair kit. Park the

vehicle on a level surface off the

right-of-way and contact an

Authorized Mazda Dealer.

Ø If the tire inflation pressure

continues to remain low, park the

vehicle on a level surface off the

right-of-way and contact an

Authorized Mazda Dealer.

If Trouble Arises

Flat Tire

7-11

Mazda6_8DL2-EA-13F_Edition1 Page469

Monday, June 10 2013 3:55 PM

Form No.8DL2-EA-13F

1 2 ... 464 465 466 467 468 469 470 471 472 473 474 ... 573 574

Kommentare zu diesen Handbüchern

Keine Kommentare

Mazda 2014 2 Spezifikationen Seite 469

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Autos Mazda 2014 2