Mazda RX-8 Bedienungshandbuch PDF herunterladen (Seite 215)

Black plate (215,1)

HomeLink should now activate your

rolling code equipped device.

NOTE

To program the remaining two HomeLink

buttons, begin with “Programming” ― step 2.

Do not repeat step 1.

For questions or comments, please contact

HomeLink at www.homelink.com or 1-

800-355-3515.

qGate operator/Canadian

Programming

Canadian radio-frequency laws require

transmitter signals to “time-out” (or quit)

after several seconds of transmission ―

which may not be long enough for

HomeLink to pick up the signal during

programming. Similar to this Canadian

law, some U.S. gate operators are

designed to “time-out” in the same

manner.

If you live in Canada or you are having

difficulties programming a gate operator

by using the “Programming” procedures

(regardless of where you live), replace

“Programming HomeLink” step 3 with

the following:

NOTE

If programming a garage door opener or gate

operator, it is advised to unplug the device

during the “cycling” process to prevent

possible overheating.

Continue to press and hold the HomeLink

button while you press and release ―

every two seconds (“cycle”) your hand-

held transmitter until the frequency signal

has successfully been accepted by

HomeLink. (The indicator light will flash

slowly and then rapidly.)

Proceed with “Programming” step 4 to

complete.

qOperating the HomeLink System

Press the programm ed HomeLink button

to operate a programmed device. The

code will continue being transmitted for a

maximum of 20 seconds.

qReprogramming the HomeLink

system

To program a device to HomeLink using a

HomeLink button previously trained,

follow these steps:

1. Press and hold the desired HomeLink

button. DO NOT release the button.

2. The indicator light will begin to flash

after 20 seconds. Without releasing the

HomeLink button, proceed with

“Programming” - step 2.

qErasing Programmed HomeLink

Buttons

To erase the existing programming from

all three operating channels, press and

hold the two outside buttons (

, )

on the auto-dimming mirror until the

HomeLink indicator light begins to flash

after approximately 20 seconds.

Verify that the programming has been

erased when you resell the vehicle.

Driving Your Mazda

Switches and Controls

5-73

RX-8_8BQ7-EA-10H_Edition1 Page215

Wednesday, July 14 2010 11:51 AM

Form No.8B

Q

7-EA-10H

1 2 ... 210 211 212 213 214 215 216 217 218 219 220 ... 441 442

Kommentare zu diesen Handbüchern

Keine Kommentare