Mazda MX-5 Bedienungshandbuch PDF herunterladen (Seite 208)

Black plate (208,1)

Gate operator/Canadian Programming

Canadian radio-frequency laws require

transmitter signals to “time-out” (or quit)

after several seconds of transmission ―

which may not be long enough for

HomeLink to pick up the signal during

programming. Similar to this Canadian

law, some U.S. gate operators are

designed to “time-out” in the same

manner.

If you live in Canada or you are having

difficulties programming a gate operator

by using the “Programming” procedures

(regardless of where you live), replace

“Programming HomeLink” step 2 with

the following:

NOTE

If programming a garage door opener or gate

operator, it is advised to unplug the device

during the “cycling” process to prevent

possible overheating.

Continue to press and hold the HomeLink

button while you press and release ―

every two seconds (“cycle”) your hand-

held transmitter until the frequency signal

has successfully been accepted by

HomeLink. (The indicator light will flash

slowly and then rapidly.) Proceed with

“Programming” step 3 to complete.

Operating the HomeLink System

Press the programm ed HomeLink button

to operate a programmed device. The

code will continue being transmitted for a

maximum of 20 seconds.

Reprogramming the HomeLink system

To program a device to HomeLink using a

HomeLink button previously trained,

follow these steps:

1. Press and hold the desired HomeLink

button. DO NOT release the button.

2. The indicator light will begin to flash

after 20 seconds. Without releasing the

HomeLink button, proceed with

“Programming” - step 1.

Erasing Programmed HomeLink

Buttons

To erase the existing programming from

all three operating channels, press and

hold the two outside buttons (

, )

on the auto-dimming mirror until the

HomeLink indicator light begins to flash

after approximately 10 seconds.

Verify that the programming has been

erased when you resell the vehicle.

qType B

NOTE

HomeLink and HomeLink house are registered

trademarks of Johnson Controls.

5-64

Driving Your Mazda

Switches and Controls

MX-5_8CM3-EA-12F_Edition1 Page208

Friday, June 8 2012 5:16 PM

Form No.8CM3-EA-12F

1 2 ... 203 204 205 206 207 208 209 210 211 212 213 ... 451 452

Kommentare zu diesen Handbüchern

Keine Kommentare