Mazda Navigation system Bedienungsanleitung PDF herunterladen (Seite 4)

TomTom Navigation voice-recognition setup

Command and Control

Previously, we told you how to use the push-to-talk

button on the steering wheel to start infotainment

voice recognition and then to use the “Navigation”

command to go to the navigation Voice Recognition

input screen.

The alternative is to use the microphone icon on the

Driving View screen to start Voice Recognition. The

navigation system then goes directly to the Voice

Recognition “Command and Control” screen as shown

below.

The navigation system plays a beep when it is ready to listen to your input. Please wait for

this beep before starting to speak. In general you hear an announcement such as “Say a

command” and then the beep. In a few cases, for example for conﬁrmation screens, only the

beep is played. When the device is ready for input the sound level is shown by the bar on

the left. If you speak too loudly it will turn red. If you speak too softly there will be no bar

shown. In a few cases the bar is not shown.

In the Command and Control screen you can say

commands to get instructions to a POI, go to the

address-input screen, increase or decrease volume etc.

You cannot say an address or say “Drive to Main Street,

Houston, Texas”. Address input is done in the address

input screen. More information on this can be found

later in this guide.

You do not have to remember speciﬁc voice commands for your navigation device. For each

command, there are a number of possible commands that you can say. For example, to make

the instructions louder you can say any of the following commands:

• Increasevolume

• TurnupVolume

• Turnvolumeup

• Louder

Tip: If you experience problems with the recognition of a command you can try using a similar

but dierent command to achieve the same results.

TomTom - Mazda NB1 Voice Recognition Instructions - July 2012

1 2 3 4 5 6 7 8 9 10 11

Keine Kommentare

Mazda Navigation system Bedienungsanleitung Seite 4