Mazda 1983 RX7 Spezifikationen PDF herunterladen (Seite 49)

100

101

IGNITION SYSTEM

Article Text (p. 5)

1983 Mazda RX7

For www.iluvmyrx7.com

Sunday, August 26, 2001 03:31PM

2) Quickly operate switch "ON " and "OFF", and make sure

test lamp flashes. If not, replace ignitor.

OVERHAUL

DISASSEMBLY

1) Remove distributor cap, rotor and seal cover. See Fig. 6.

Remove igniters and attaching screws from distributor housing. Remove

clips holding vacuum diaphragm links. Remove attaching screws and

vacuum control units from distributor housing. Remove condenser.

2) Remove reluctor shaft attaching screw from end of shaft.

Remove pick-up coil base bearing attaching screws. Remove reluctor,

reluctor shaft, pick-up coils and coil base bearing assembly from top

of distributor drive shaft.

3) Remove reluctor from reluctor shaft, using puller. Remove

spring pin. Remove governors by removing springs. Drive lock pin out

of drive gear, using a small drift. Remove gear and washers. Remove

drive shaft through top of distributor housing.

REASSEMBLY

1) Inspect distributor cap and rotor for cracks, carbon

tracks, and burned or corroded terminals.

2) Assemble distributor in reverse order of disassembly,

noting the following: Install reluctor shaft onto distributor drive

shaft, engaging slots of reluctor shaft and governor pins. Install

pick-up coil and coil base bearing assembly and tighten attaching

screws. Install reluctor on shaft, driving spring pin in with a punch.

Fig. 6: Disassembled View of RX7 Mitsubishi Distributor

END OF ARTICLE

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 457 458

Kommentare zu diesen Handbüchern

Keine Kommentare

Mazda 1983 RX7 Spezifikationen Seite 49

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Autos Mazda 1983 RX7