Mazda 1983 RX7 Spezifikationen PDF herunterladen (Seite 74)

BRAKE SYSTEM

Article Text (p. 3)

1983 Mazda RX7

For www.iluvmyrx7.com

Sunday, August 26, 2001 04:54PM

2) On RX7 remove lower caliper guide pin and

pivot caliper body up out of way. On GLC Wagon and Pickups remove

locking clips and stopper plates.

3) Remove caliper body and hang from frame with wire. Do not

disconnect hydraulic lines. On all models, remove anti-rattle springs

(clips), pads, and shims, if equipped.

Installation

1) To install, reverse removal procedure. Before mounting

caliper, loosen bleed screw, and seat piston. Tighten bleed screw.

2) After pad installation, depress brake pedal several times

to seat pads. Bleed hydraulic system, if required.

NOTE: Grease pad mounting support, caliper contact area, and shims

with special grease (NLGI No. 2 or equivalent).

REAR DISC BRAKE PADS

Removal (RX7)

1) Raise and support the rear of the vehicle. Remove wheel.

Disconnect parking brake cable from caliper. Remove lower caliper

attaching bolt.

2) Lift the lower side of caliper. Remove anti-rattle

spring. Remove disc brake pads and shims.

Installation

1) Using brake piston wrench (49 FA18 602), turn piston

clockwise until piston is inserted into caliper fully.

2) Position piston so that dowel on pad will seat in piston

stopper groove. To complete installation, reverse removal procedure.

FRONT DISC BRAKE CALIPER

Removal

1) Raise and support the front of the vehicle. Remove the

wheel. Disconnect and plug the fluid line at caliper. On RX7, remove

lower caliper bolt, lift the caliper body, and remove by sliding

toward the inside of the vehicle.

2) On GLC Wagon and Pickups, remove locking clips, stopper

plates, and anti-rattle spring. Lift off caliper. Remove disc pads as

previously described.

Installation

To install, reverse removal procedure and bleed hydraulic

system.

REAR BRAKE CALIPER

Removal (RX7)

1) Raise and support the rear of the vehicle. Remove the

wheel. Disconnect parking brake cable from caliper.

2) Remove caliper attaching bolt (lower side). Lift up

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 457 458

Kommentare zu diesen Handbüchern

Keine Kommentare

Mazda 1983 RX7 Spezifikationen Seite 74

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Autos Mazda 1983 RX7