Mazda 2001 Tribute Bedienungsanleitung PDF herunterladen

INSTALL/REMOVAL INSTRUCTIONS: WINDOW REGULATOR

748-710

Disclaimer:

Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a quali ed auto technician

before attempting to perform any work you are not quali ed to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage

or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Tra c Safety

Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.

ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain speci c service procedures for this part. If you do not have

a service manual or lack the skill to install this part, it is recommended that you seek the services of a quali ed technician. Pay special

attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.

No reproductions in whole or in part without prior written approval.

REMOVAL/INSTALL OF WINDOW REGULATOR (748-710)

Mazda Tribute 2001–06

General Tech Tips:

• Use painter’s tape rather than duct tape to secure window. It will not damage paint or leave sticky residue.

• A plastic pry tool is useful. It will not easily damage delicate trim like a screwdriver or metal pry bar.

• The replacement regulator should have a liberal amount of grease on slide area. If there is not much grease

present, white lithium grease works well to lubricate the slide area.

• Aftermarket window tinting can cause the window to travel slower and put additional strain on the window

regulator assembly.

• Window run channels should be cleaned and lubricated before installation of a new window regulator

assembly. Silicone spray works well.

PLEASE WEAR SAFETY

GLASSES!

Tools required for removal and

installation of window regulator and

motor assembly:

• Silicone spray lubricant

• Trim panel removal tool

• Pick

• Saddle cup assembly, tape or wedge

to hold window in place

• Flat-blade screwdriver or plastic pry

tool

• 10 mm socket or driver

• Phillips screwdriver

• Grease pencil or marker

1 2 3 4 5 6 ... 12 13