Mazda 2008 B2300 Truck Bedienungsanleitung PDF herunterladen (Seite 122)

13. Maximum Permissible Inflation Pressure: Indicates the tire

manufacturers’ maximum permissible pressure and/or the pressure at

which the maximum load can be carried by the tire. This pressure is

normally higher than the manufacturer’s recommended cold inflation

pressure which can be found on the Safety Compliance Certification

Label or Tire Label which is located on the B-Pillar or the edge of

the driver’s door. The cold inflation pressure should never be set

lower than the recommended pressure on the vehicle label.

The tire suppliers may have additional markings, notes or warnings such

as standard load, radial tubeless, etc.

Additional information contained on the tire sidewall for “LT” type

tires

“LT” type tires have some additional

information beyond those of “P”

type tires; these differences are

described below:

1. LT: Indicates a tire, designated

by the Tire and Rim Association

(T&RA), that is intended for

service on light trucks.

2. Load Range/Load Inflation

Limits: Indicates the tire’s

load-carrying capabilities and its

inflation limits.

3. Maximum Load Dual lb. (kg)

at psi (kPa) cold: Indicates

the maximum load and tire

pressure when the tire is used as a dual; defined as four tires on the

rear axle (a total of six or more tires on the vehicle).

4. Maximum Load Single lb. (kg) at psi (kPa) cold: Indicates the

maximum load and tire pressure when the tire is used as a single;

defined as two tires (total) on the rear axle.

2008 B-Series (mbs)

Owners Guide (post-2002-fmt)

USA (fus)

Tires, Wheels and Loading

122

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 240 241

Keine Kommentare

Mazda 2008 B2300 Truck Bedienungsanleitung Seite 122