Mazda 2008 B2300 Truck Bedienungsanleitung PDF herunterladen (Seite 188)

WARNING: When a wheel is installed, always remove any

corrosion, dirt or foreign materials present on the mounting

surfaces of the wheel or the surface of the wheel hub, brake

drum or brake disc that contacts the wheel. Ensure that any

fasteners that attach the rotor to the hub are secured so they

do not interfere with the mounting surfaces of the wheel.

Installing wheels without correct metal-to-metal contact at the

wheel mounting surfaces can cause the wheel nuts to loosen

and the wheel to come off while the vehicle is in motion,

resulting in loss of control.

Note: Inspect the wheel pilot hole

prior to installation. If there is

visible corrosion in wheel pilot hole,

remove loose particles by wiping

with clean rag and apply grease.

Apply grease only to the wheel pilot

hole surface by smearing a “dime”

(1 square cm) sized glob of grease

around the wheel pilot surface (1)

with end of finger. DO NOT apply

grease to lugnut/stud holes or

wheel-to-brake surfaces.

OVERHEATING

If the temperature gauge indicates overheating and you experience

power loss, you hear a loud knocking or pinging noise, the engine is

probably too hot.

If this happens:

1. Drive safely to the side of the road and park off the right-of-way.

2. Shift the automatic transmission into P (Park) or the manual

transmission into the neutral position, and apply the parking brake.

3. Turn off the air conditioner.

WARNING: Steam from an overheated engine is dangerous. The

escaping steam could seriously burn you. Open the hood ONLY

after steam is no longer escaping from the engine.

4. Check whether coolant or steam is escaping from under the hood or

from the engine compartment.

2008 B-Series (mbs)

Owners Guide (post-2002-fmt)

USA (fus)

Roadside Emergencies

188

1 2 ... 183 184 185 186 187 188 189 190 191 192 193 ... 240 241

Keine Kommentare

Mazda 2008 B2300 Truck Bedienungsanleitung Seite 188