Mazda 2008 B2300 Truck Bedienungsanleitung PDF herunterladen (Seite 64)

Note: The panic alarm will only operate when the ignition is in the 2

(LOCK) or 3 (OFF) position.

Replacing the battery

The remote entry transmitter uses one coin type three-volt lithium

battery CR2032 or equivalent.

To replace the battery:

1. Twist a thin coin between the

two halves of the remote entry

transmitter near the key ring.

DO NOT TAKE THE RUBBER

COVER AND CIRCUIT BOARD

OFF THE FRONT HOUSING OF

THE REMOTE ENTRY

TRANSMITTER.

2. Do not wipe off any grease on

the battery terminals on the

back surface of the circuit

board.

3. Remove the old battery. Note: Please refer to local regulations when

disposing of transmitter batteries.

4. Insert the new battery. Refer to the diagram inside the remote entry

transmitter for the correct orientation of the battery. Press the

battery down to ensure that the battery is fully seated in the battery

housing cavity.

5. Snap the two halves back together.

Note: Replacement of the battery will not cause the remote transmitter

to become deprogrammed from your vehicle. The remote transmitter

should operate normally after battery replacement.

Replacing lost remote entry transmitters

If you would like to have your remote entry transmitter reprogrammed

because you lost one, or would like to buy additional remote entry

2008 B-Series (mbs)

Owners Guide (post-2002-fmt)

USA (fus)

Locks and Security

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 240 241

Keine Kommentare

Mazda 2008 B2300 Truck Bedienungsanleitung Seite 64