Mazda 2009 RX-8 Bedienungsanleitung PDF herunterladen (Seite 252)

Black plate (252,1)

(Releasing a locked channel)

1. Select a channel to be released by

pressing the tune button. Example:

Select the locked channel (i.e. 100). At

this time, “SR1 LOCK 100” is

displayed.

(Registered ID code input preparation)

2. Hold the auto memory button, then

press channel preset button 6, hold

both buttons together for 1.5 seconds.

3. “ENTER PIN” appears for 2 seconds

which indicates that it is in code input

mode.

4. “SR1 - - - -” appears, which indicates

that it is ready for code input.

(Registered ID code input)

5. Input the registered ID code using

channel preset buttons 1-4. Example:

When the registered ID code is “2323”,

input “2323”. At this time “SR1 2323”

is displayed. Press the auto memory

button after the code is input.

NOTE

If “Err” is displayed, go to the

“INITIALIZATION OF ID CODE” section to

reset the ID code to [0000].

(Registered ID code input

determination)

6. Determine the input code by pressing

the auto memory button briefly.

7. If it does not match the registered code,

“SR1 Err” is displayed and then it

returns to “SR1 - - - -”.

8. If it matches the registered code,

“SR1 UNLOCK” appears for 3

seconds which indicates that the code

input has been completed.

9. “SR1 100” appears which indicates that

the parental lock is off. At this time,

sound is heard.

(How to clear the message)

l

Press any of the following FM/AM,

SAT, CD, MEDIA, CAT, ESN/DISP,

Instant replay, POWER buttons.

l

Turn the ACC off or insert a CD.

NOTE

l

If an ID code is not input for 10 seconds,

“Err” is displayed and it returns to the

former display.

l

Channel preset buttons 1, 2, 3, 4 and the

auto memory button are used for input of

the ID code. Buttons 5 and 6 cannot be

used.

Error signs

(1) Depending on the surrounding

conditions (such as large trees,

buildings, or tunnels) and special

weather conditions, the reception of

SIRIUS radio waves may be

decreased or temporarily interrupted.

“ACQUIRING SIGNAL” may

appear.

(2) In case of an antenna malfunction,

“ANTENNA FAIL” is displayed.

Check the satellite radio antenna,

antenna cable and DLP antenna

connector.

NOTE

If a broken DLP* unit is replaced with a new

unit, cancel the license for the broken unit and

make sure to carry out new registration for the

replaced unit. If the license for the broken unit

is not canceled, you will be charged a

reception fee for both units.

* DLP: Down Link Processor

(SATELL ITE RADIO Module)

6-44

Interior Comfort

Audio System

RX-8_8Z09-EA-08C_Edition3 Page252

Thursday, July 3 2008 2:23 PM

Form No.8Z09-EA-08C

1 2 ... 247 248 249 250 251 252 253 254 255 256 257 ... 429 430

Kommentare zu diesen Handbüchern

Keine Kommentare