Mazda MAZDA3 4-Door Bedienungshandbuch PDF herunterladen (Seite 167)

4

–

41

When Driving

Switches and Controls

CAUTION

¾

Do not shade the rain sensor by

adhering a sticker or a label on the

windshield. Otherwise the rain sensor

will not operate correctly.



¾

When the wiper lever is in the AUTO

position and the ignition is switched ON,

the wipers may move automatically in

the following cases:

¾

If the windshield above the rain

sensor is touched or wiped with a

cloth.

¾

If the windshield is struck with a hand

or other object from either outside or

inside the vehicle.



Keep hands and scrapers clear of the

windshield when the wiper lever is in

the AUTO position and the ignition is

switched ON as  ngers could be pinched

or the wipers and wiper blades damaged

when the wipers activate automatically.



If you are going to clean the windshield,

be sure the wipers are turned o

completely (when it is most likely

that the engine is left running) this is

particularly important when clearing ice

and snow.

NOTE

y

Switching the auto-wiper lever from the

to the position while driving

activates the windshield wipers once,

after which they operate according to

the rainfall amount.

y

The auto-wiper control may not operate

when the rain sensor temperature is

about -10 °C (14 °F) or lower, or about

85 °C (185 °F) or higher.

y

If the windshield is coated with water

repellent, the rain sensor may not be

able to sense the amount of rainfall

correctly and the auto-wiper control

may not operate properly.

y

If dirt or foreign matter (such as ice or

matter containing salt water) adheres

to the windshield above the rain sensor,

or if the windshield is iced, it could

cause the wipers to move automatically.

However, if the wipers cannot remove

this ice, dirt or foreign matter, the auto-

wiper control will stop operation. In

this case, set the wiper lever to the low

speed position or high speed position

for manual operation, or remove the ice,

dirt or foreign matter by hand to restore

the auto-wiper operation.

y

If the auto-wiper lever is left in the

position, the wipers could operate

automatically from the effect of strong

light sources, electromagnetic waves, or

infrared light because the rain sensor

uses an optical sensor. It is

recommended that the auto-wiper lever

be switched to the

position other

than when driving the vehicle under

rainy conditions.

y

The auto-wiper control functions can

be turned off. Refer to Personalization

Features on page 9-10 .

Mazda3_8DC9-EA-14A_Edition1.indb 41 2013/10/18 14:55:57

1 2 ... 162 163 164 165 166 167 168 169 170 171 172 ... 523 524

Kommentare zu diesen Handbüchern

Keine Kommentare