Mazda MX-5 Bedienungshandbuch PDF herunterladen (Seite 212)

Black plate (212,1)

5. Press and hold the just-trained

HomeLink button and observe the

indicator light.

If the indicator light stays on constantly,

programming is complete and your

device should activate when the

HomeLink button is pressed and released.

NOTE

To program the remaining two HomeLink

buttons, begin with “Programming”― step 2.

Do not repeat step 1.

If the indicator light blinks rapidly for

two seconds and then turns to a

constant light, continue with

“Programming” steps 6―8 to complete

the programming of a rolling code

equipped device (most commonly a

garage door opener).

6. At the garage door opener receiver

(motor-head unit) in the garage, locate

the “learn” or “smart” button. This can

usually be found where the hanging

antenna wire is attached to the motor-

head unit.

7. Firmly press and release the “learn” or

“smart” button. (The name and color of

the button may vary by manufactur er.)

NOTE

There are 30 seconds in which to initiate step

8.

8. Return to the vehicle and firmly press,

hold for two seconds and release the

programmed HomeLink button. Rep eat

the “press/hold/release” sequence a

second time, and, depending on the

brand of the garage door opener (or

other rolling code equipped device),

repeat this sequence a third time to

complete the progra mming proces s.

HomeLink should now activate your

rolling code equipped device.

NOTE

To program the remaining two HomeLink

buttons, begin with “Programming”― step 2.

Do not repeat step 1.

For questions or comments, please contact

HomeLink at www.homelink.com or 1-

800-355-3515.

Gate operator/Canadian Programming

Canadian radio-frequency laws require

transmitter signals to “time-out” (or quit)

after several seconds of transmission ―

which may not be long enough for

HomeLink to pick up the signal during

programming. Similar to this Canadian

law, some U.S. gate operators are

designed to “time-out” in the same

manner.

If you live in Canada or you are having

difficulties programming a gate operator

by using the “Programming” procedures

(regardless of where you live), replace

“Programming HomeLink” step 3 with

the following:

NOTE

If programming a garage door opener or gate

operator, it is advised to unplug the device

during the “cycling” process to prevent

possible overheating.

Continue to press and hold the HomeLink

button while you press and release ―

every two seconds (“cycle”) your hand-

held transmitter until the frequency signal

has successfully been accepted by

HomeLink. (The indicator light will flash

slowly and then rapidly.) Proceed with

“Programming” step 4 to complete.

5-68

Driving Your Mazda

Switches and Controls

MX-5_8DG6-EA-13F_Edition1 Page212

Thursday, May 30 2013 10:51 AM

Form No.8DG6-EA-13F

1 2 ... 207 208 209 210 211 212 213 214 215 216 217 ... 451 452

Kommentare zu diesen Handbüchern

Keine Kommentare