Mazda 2003 MPV Bedienungsanleitung PDF herunterladen (Seite 29)

MA30

Mazda ReferenceMA000

Figure MA000-28

NOTE:

i Driving condition before driving at constant speed is not specified.

4. Stop vehicle and access ON BOARD SYSTEM to verify OBD monitoring status:

– If completed, OBD monitoring status items change from non-completed to

completed.

– If not completed, turn key off, then repeat from Step 3.

5. Access DIAGNOSTIC MONITORING TEST to verify monitoring results:

– If detected values are not within specifications, repair has not been completed.

6. Verify no DTCs set.

Mode 6 (EVAP System Repair Verification Drive Mode)

NOTE:

i If “EVAP System Repair Verification Drive Mode” cannot be performed (you cannot drive the

vehicle under the specified condition), perform evaporative system test procedure as an

alternative. (See “Evaporative System Test” in “Tests and Procedures” section of Driveability

Troubleshooter.)

z To perform this drive mode:

1. Verify that the following PIDs are within specifications. All PIDs must be within

specifications before engine is started to initiate evaporative system test.

– BARO: 21.3 inHg (72.3 kPa, 542 mmHg) or higher

– IAT: 41°F to 95°F (5°C to 35°C)

– Fuel tank level: 15% to 85%

– Battery (+): 10.9V to 14.6V

2. Clear DTCs from PCM memory.

3. Start the engine and idle it for 10 seconds or more, then turn key to OFF.

4. Leave the vehicle is this condition for 5 hours or more.

TIME (Minutes)

VEHICLE SPEED

Idle

Key

Off

Start

Engine

Than

3 min.

Than

1 min.

Than

5 min.

Above 40 mph (64 kph):

MTX in 5th Gear,

ATX in D range

45 to 55 mph (72 to 88 kph):

MTX in 5th Gear,

ATX in D range

MODE 3 (HO2S Heater, HO2S, and TWC Repair Verification Drive Mode)

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 48 49

Kommentare zu diesen Handbüchern

Keine Kommentare

Mazda 2003 MPV Bedienungsanleitung Seite 29

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Autos Mazda 2003 MPV