Mazda 2003 MPV Bedienungsanleitung PDF herunterladen (Seite 48)

MA49

Mazda ReferenceMA000

Mode 1 (PCM Adaptive Memory Produce Drive Mode)

z To perform this drive mode:

1. Start the engine and warm completely.

2. Verify that the following conditions and correct if necessary:

– All accessory loads (A/C, headlights, blower fan, rear window defroster) are off.

– Initial ignition timing and idle speed are within specification.

3. Perform no load racing at 2500 RPM to 3500 RPM for more than 15 seconds.

4. Continuously perform no load racing at the 4500 RPM to 5000 RPM for more than 15

seconds.

5. Idle the engine for more than 1 minute after the cooling fan has stopped.

6. Turn the key off.

Mode 3 (HO2S heater, HO2S, and TWC Repair Verification Drive

Mode)

z To perform this drive mode:

1. Perform Mode 1 first.

2. Verify that all accessory loads (A/C, headlights, blower fan, rear window defroster) are off.

3. Drive vehicle as shown in Figure MA000-42. Driving condition before driving at constant

speed is not specified.

Figure MA000-42

4. Stop the vehicle and access the ON BOARD SYSTEM READINESS to inspect Drive

Mode completion status:

– If completed, RFC changes to read Yes.

– If not completed, turn key off, then repeat Step 3.

5. Access DIAGNOSTIC MONITORING TEST RESULTS to inspect monitor results:

– If not within specification, the repair has not been completed.

TIME (Minutes)

VEHICLE SPEED

Idle

Key

Off

Start

Engine

Than

3 min.

Than

1 min.

Than

5 min.

Above 55 mph (89 kph):

MTX in 5th Gear,

ATX in D range

45 to 55 mph (72 to 88 kph):

MTX in 5th Gear,

ATX in D range

MODE 3 (HO2S Heater, HO2S, and TWC Repair Verification Drive Mode)

1 2 ... 43 44 45 46 47 48 49

Kommentare zu diesen Handbüchern

Keine Kommentare

Mazda 2003 MPV Bedienungsanleitung Seite 48

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Autos Mazda 2003 MPV