Mazda 2003 MPV Bedienungsanleitung Seite 35

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 49
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 34
MA36
Mazda ReferenceMA000
Figure MA000-33
EVAP System Repair Verification Drive Mode
NOTE:
i If “EVAP System Repair Verification Drive Mode” cannot be performed (it is impossible to drive
the vehicle as indicated), perform evaporative system test procedure as an alternative.
z To perform this drive mode:
1. Verify that all of the following PIDs are within the following specifications:
BARO: 21.2 inHg (72.2 kPa, 541 mmHg) or higher
IAT: 41°F to 95°F(5°C to 35°C)
FTL: 15% to 85%
B+: above 10.9 V
All PIDs must be within specifications before engine is started to initiate the evaporative
system test.
2. Clear DTC from PCM memory.
3. Start engine and idle for more than 10 seconds, then turn key off.
4. Leave vehicle for 5 hours or more.
5. Start engine and idle for more than 15 minutes.
6. Drive vehicle at 40 to 50 mph (65 to 80 kph) for more than 5 minutes.
7. Stop vehicle and turn key off.
8. Leave vehicle as it is for 10 minutes or more.
9. Start the engine.
10. Access the ON BOARD SYSTEM READINESS to verify OBD monitoring status:
If completed, OBD monitoring status items change to read completed.
If not completed, turn key off, then go back to Step 1.
11. Access DIAGNOSTIC MONITORING TEST RESULTS to verify the monitor results:
If detected values are not within specification, repair has not completed.
12. Verify no DTCs set.
TIME
VEHICLE SPEED
Idle
Key
Off
Start
Engine
45 to 55 mph (72 to 88 kph):
MTX in 5th Gear,
ATX in D Range
HO2S Heater, HO2S, and TWC Repair Verification Drive Mode
More Than
5 min.
1 min.
Above 55 mph (89 kph):
MTX in 5th Gear,
ATX in D Range
3 min.
2500 rpm
About 10 sec.
About 5 sec.
Maintain an engine speed of 2500 rpm for at least 10 secods,
then decelerate with engine braking only for 5 seconds.
Repeat this cycle 10 times.
Seitenansicht 34
1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 48 49

Kommentare zu diesen Handbüchern

Keine Kommentare