Mazda CX-9 Bedienungshandbuch PDF herunterladen (Seite 259)

Black plate (259,1)

The Hom eLink system provides 3 buttons

which can be individually selected and

programmed using the transmitters for

current, on-market devices as follows:

1. Position the end of your hand-held

transmitter 2.5―7.5 cm (1―3 inches)

away from the HomeLink button you

wish to program while keeping the

indicator light in view.

2. Simultaneously press and hold both the

chosen HomeLink and hand-held

transmitter buttons. Do not release the

buttons until step 3 has been

completed.

NOTE

Some gate operators and garage door openers

may require you to replace this Programming

Step 2 with procedures noted in the “Gate

Operator/Canadian Programming ” section.

3. After the HomeLink indicator light

changes from a slow to a rapidly

blinking light, release both the

HomeLink and hand-held transmitter

buttons.

NOTE

If the HomeLink indicator light does not

change to a rapidly blinking light, contact

HomeLink at www.homelink.com or call 1-

800-355-3515 for assistance.

4. Firmly press and hold the programmed

HomeLink button for five seconds, and

then release it. Perform this operation

two times to activate the door. If the

door does not activate, press and hold

the just-trained HomeLink button and

observe the indicator light.

If the indicator light stays on constantly,

programming is complete and your

device should activate when the

HomeLink button is pressed and released.

NOTE

To program the remaining two HomeLink

buttons, begin with “Programming”― step 1.

If the indicator light blinks rapidly for

two seconds and then turns to a

constant light, continue with

“Programming” steps 5―7 to complete

the programming of a rolling code

equipped device (most commonly a

garage door opener).

5. At the garage door opener receiver

(motor-head unit ) in the garage, locate

the “learn” or “smart” button. This can

usually be found where the hanging

antenna wire is attached to the motor-

head unit.

6. Firmly press and release the “learn” or

“smart” button. (The name and color of

the button may vary by manufacturer.)

NOTE

There are 30 seconds in which to initiate step

7.

7. Return to the vehicle and firmly press,

hold for two seconds and release the

programmed HomeLink button. Repeat

the “press/hold/release” sequence a

second time, and, depending on the

brand of the garage door opener (or

other rolling code equipped device),

repeat this sequence a third time to

complete the progra mming process.

HomeLink should now activate your

rolling code equipped device.

NOTE

To program the remaining two HomeLink

buttons, begin with “Programming”― step 1.

For questions or comments, please contact

HomeLink at www.homelink.com or 1-

800-355-3515.

Driving Your Mazda

Switches and Controls

5-83

CX-9_8CM9-EA-12I_Edition1 Page259

Thursday, September 13 2012 2:36 PM

Form No.8CM9-EA-12I

1 2 ... 254 255 256 257 258 259 260 261 262 263 264 ... 597 598

Kommentare zu diesen Handbüchern

Keine Kommentare