1 GENUINE Remote engine start INSTALLATION INSTRUCTIONS Thank you for purchasing a genuine Mazda accessory. Before removal and installation, be s
10 Dashboard under cover removal 1. Detach hooks A (2 locations) in the direction of arrow (1) shown in the figure. 2. Pull the dashboa
11 1. Install the hood switch to the hood latch and secure it using a screw (1 location). 2. Hook the hood switch harness to the ho
12 6. Secure the hood switch harness to the shroud panel using tie wraps (Black). 7. Route the hood switch harness along the vehicle wiring
13 Vehicles with wiring harness terminal A (Black) shown in figure (Type A) 10. Branch connect the hood switch harness (Black) to the vehicl
14 1. Cut 1 piece of urethane tape to the dimensions shown in the figure. 2. Wrap urethane tapeⓐ around the RES ECU. 3. Degreas
15 7. Degrease the RES ECU installation position at the upper back of the glove compartment (dashboard) using primer, and affix double-sided adhesiv
16 11. Secure the harness to the vehicle wiring harness using a tie wraps (White). 12. Tighten the dashboard member bolt (vehicle part)
17 1. Reinstall parts in the reverse order of the installation procedure in【PARTS REMOVAL】. 2. After installing the passenger's side lower p
Date , , VIN. Approved Checked Person in charge INSTALLATION INSPECTION SHEET MAZDA6 Remote engine start C930 V7 620 (CONTROLLER KIT)
Inspection Parts Inspection Items Inspection Check Remote Start Transmitter Operation check 2. Perform the vehicle condition check using the remote
2 ▼ Installation view 1. PARTS (Sold separately) Hood switch (Only for vehicle without theft-deterrent or
3 ▼ Parts list CONTOROLLER KIT (Part No. C930 V7 620) Part Part name Qty. Part Part name Qty. Part Part name Qty. Remote Start Transmitter (C9
4 REQUIRED TOOLS ☆Socket wrench ☆Torque wrench ☆Tape-wrapped flathead screwdriver ☆Phillips screwdriver ☆Nipper ☆Pliers ☆Scissors
5 4.CONNECTION DIAGRAM TYPE B TYPE A Insert to empty terminal (TYPE A and B) Figure shows connector viewed from harness side.
6 Negative battery cable disconnection 1. Set the selector lever to P range. 2. Disconnect the negative battery cable and wrap tape aro
7 ③ Main fuse cover removal 1. Detach the main fuse cover tab (1 location), and lift the rear part of the main fuse cover to remove it.
8 Front scuff plate (Passenger's side) removal 1. Take the shaded area shown in the figure, detach tab A while pulling the front scuff plat
9 Glove compartment removal 1. Push the glove compartment in the direction of the arrow (1) and hooks A (2 locations). 2. Pull the stay damp
Kommentare zu diesen Handbüchern