Mazda 0000-8F-N02B Bedienungshandbuch PDF herunterladen (Seite 17)

4280159 Rev. A 10/10

RE-ASSEMBLY

1. Re-install the following components:

a. Plug the ignition key light back into the lower steering

column cover (Retractable Key equipped vehicles only)

and carefully snap the steering column cover halves back

together. (FIGURE WW)

b. Re-install the (3) phillips head screws. Verify operation

of the tilt steering wheel.

CAUTION: Do not pierce the remote start wiring with the

steering column cover halves or phillips head screws dur

ing reassembly.

c. Replace the ignition knob by pushing toward the ignition

switch until it snaps in place. (Smart-Key equipped ve-

hicles only)

d. Re-install the black, lower dash panel by engaging the

single clip located at the front, center of the panel. Re-

install both plastic fasteners and push the plastic center

button down until flush with fastener to engage.

(FIGURE XX)

e. Re-install the driver’s side kick panel by engaging the

retaining clip on the panel. Re-install the plastic nut and

rubber weatherstrip on the kick panel. (FIGURE YY)

FIGURE XX

FIGURE WW

Plastic Nut

FIGURE YY

95 mm

12 mm

EMERGENCY OVERRIDE/PROGRAMMING BUTTON MOUNTING

1. Locate the previously removed driver’s side kick panel cover.

2. Drill a 9/32” hole at the top of the panel, exactly 12 mm down and 95 mm from the far edge.

3. Route the emergency override/programming button from the remote start harness down to the kick

panel.

4. Mount the emergency override/programming button in the drilled hole from behind and screw the mounting

cap in place. (FIGURE VV)

NOTE: DISCARD THE LOCK WASHER FROM THE EMERGENCY OVERRIDE/PROGRAMMING

BUTTON, IT IS NOT USED ON THIS MODEL.

FIGURE VV

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 25 26

Keine Kommentare

Mazda 0000-8F-N02B Bedienungshandbuch Seite 17