Mazda 0000-8F-N02B Bedienungshandbuch PDF herunterladen (Seite 9)

4280159 Rev. A 10/10

GROUND CONNECTION

1. Locate the 10 mm factory bolt, mounted high up under the dash, near the vehicle dashwall,

supporting the factory “Unit - Light Auto Off” module. (FIGURE V)

2. Using a 10 mm ratchet, remove the 10 mm bolt.

3. Using the 10 mm bolt just removed, secure the remote start harness BLACK/ORANGE ground

wire with ringlet and tighten with a 10 mm ratchet.

NOTE: USING A 3/8” DRIVE TORQUE WRENCH, MAKE SURE THAT THE 10 mm GROUND

BOLT IS SECURELY TIGHTENED TO 78-121 INCH/POUNDS.

HOOD SAFETY SWITCH WIRE CONNECTIONS

1. Locate the BLACK and GRAY/RED wires from the remote start harness.

2. Using the (2) supplied IDC wire taps (in hood safety switch parts bag), connect the wires listed

below together and crimp the IDC wire taps in place using pliers. Ensure that a complete and

secure connection is made.

HOOD SAFETY SWITCH WIRE REMOTE START HARNESS WIRE

Dark GRAY GRAY/RED

Dark GRAY BLACK

NOTE: Switch is not polarity sensitive.

NOTE: Refer to Page 2 for IDC Wire Tap Procedure and Wire color code information.

FIGURE V

Unit-Light Auto Off

Module

Steering

Column

10 mm

Factory Bolt

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 25 26

Keine Kommentare

Mazda 0000-8F-N02B Bedienungshandbuch Seite 9