Mazda 0000-8F-N02B Bedienungshandbuch PDF herunterladen (Seite 18)

4280159 Rev. A 10/10

RE-ASSEMBLY, continued

f. Re-install the driver’s side scuff plate by engaging all three

clips. (FIGURE ZZ)

2. Re-install and Reconnect Battery:

a. Carefully re-install battery into vehicle’s battery tray.

b. Re-install battery hold-down bracket by engaging lower

retainers into battery tray, away from vehicle dashwall and

tightening both 10 mm nuts to 78-121 inch/pounds.

(FIGURE AAA)

c. Reconnect the positive battery terminal only, at this time.

(FIGURE AAA)

10 mm

Socket

FIGURE AAA

FIGURE ZZ

SYSTEM POWER-UP

1. Verify that all connections are secure as per installation instructions.

2. Ensure 15 amp Room fuse is properly installed in dash fuse panel.

3. Turn the ignition key to the RUN position.

4. Reconnect the negative battery terminal.

5. Turn the ignition key to the OFF position.

WARNING: / AVERTISSEMENT

This vehicle is equipped with a remote controlled engine starter.

To reduce the risk of serious Injury or death, switch engine starter

system into service mode and disconnect the vehicle battery

before performing any service on the vehicle.

Ce véhicule est doté d'un démarreur à distance. Pour réduire les

risques de blessures graves ou mortelles, mettre le démarreur à

distance en mode service et débrancher la batterie du véhicule

avant d'effectuer des travaux d'entretien sur celui-ci.

1. Open the engine hood and locate the open area on the plasitc core support cover, above the

hood latch. (FIGURE BBB)

2. Using an alcohol pad, clean the mounting surface thoroughly.

3. Remove the backing on the underhood sticker and mount in place.

4. Close engine hood.

UNDERHOOD WARNING LABEL MOUNTING

FIGURE BBB

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24 25 26

Keine Kommentare

Mazda 0000-8F-N02B Bedienungshandbuch Seite 18