Mazda 2012 CX-7 Spezifikationen PDF herunterladen (Seite 178)

Black plate (178,1)

WARNING

Do not use the HomeLink system with

any garage door opener that lacks the

safety stop and reverse feature:

Using the HomeLink system with any

garage door opener that lacks the

safety stop and reverse feature as

required by federal safety standards

is dangerous. (This includes garage

doors manufactured before April 1,

1982.)

Using these garage door openers can

increase the risk of serious injury or

death. For further information,

contact HomeLink at 1-800-355-3515

or www.homelink.com or your

Authorized Mazda Dealer.

Always check the areas surrounding

garage doors and gates for people or

obstructions before programming or

during operation of the HomeLink

system:

Programming or operating the

HomeLink system without verifying

the safety of areas surrounding

garage doors and gates is dangerous

and could result in an unexpected

accident and serious injury if

someone were to be hit.

NOTE

The programming will not be erased even if

the battery is disconnected.

qPre-programming the HomeLink

System

NOTE

It is recommended that a new battery be

placed in the hand-held transmitter of the

device being programmed to HomeLink for

quicker training and accurate transmission of

the radio-frequency signal.

l

Verify that there is a remote control

transmitter available for the device you

would like to program.

l

Disconnect the power to the device .

q

Programming the HomeLink System

CAUTION

When programming a garage door

opener or a gate, disconnect the

power to these devices before

performing programming, as

continuous operation of the devices

could damage the motor.

The Hom eLink system provides 3 buttons

which can be individually selected and

programmed using the transmitters for

current, on-market devices as follows:

1. Position the end of your hand-he ld

transmitter 2.5―7.5 cm (1―3 inches)

away from the HomeLink button you

wish to program while keeping the

indicator light in view.

2. Simultaneously press and hold both the

chosen HomeLink and hand-held

transmitter buttons. Do not release the

buttons until step 3 has been

completed.

NOTE

Some gate operators and garage door openers

may require you to replace this Programming

Step 2 with procedures noted in the “Gate

Operator/Canadian Programming” section.

3. After the HomeLink indicator light

changes from a slow to a rapidly

blinking light, release both the

HomeLink and hand-held transmitter

buttons.

4-54

When Driving

Switches and Controls

CX-5_8CA5-EA-11L_Edition3 Page178

Friday, June 22 2012 3:45 PM

Form No.8CA5-EA-11L

1 2 ... 173 174 175 176 177 178 179 180 181 182 183 ... 487 488

Kommentare zu diesen Handbüchern

Keine Kommentare