Mazda 13B-MSP Bedienungsanleitung Seite 37

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 71
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 36
MECHANICAL
01–10–20
Engine Workshop Manual 13B-MSP (Multi Side Port) (1773–1U–03C)
1. Measure the height of the apex seal spring using
a vernier caliper with the spring placed on a
surface plate.
If it is less than the minimum specification,
replace the apex seal spring.
Standard height
5.4 mm {0.213 in}
Minimum height
3.5 mm {0.148 in}
End Of Sie
ROTOR BEARING OIL CLEARANCE INSPECTION
CHU011011B10E08
1. Measure the outer diameter of the rotor journal
using a micrometer.
Caution
Measure the rotor journal at a point
slightly off-center since the center
section is raised. Do not measure at the
center because it does not contact the
rotor bearing.
2. Measure the inner diameter of the rotor bearing
using a cylinder gauge.
3. Calculate the rotor bearing oil clearance from the
rotor journal outer diameter and the rotor bearing
inner diameter.
Rotor bearing oil clearance = (rotor bearing
inner diameter) – (rotor journal outer
diameter)
If it exceeds the minimum specification,
replace the rotor bearing. (See 01–10–21
ROTOR BEARING REPLACEMENT.)
If not within the specification, even with the
rotor bearing replaced, replace the eccentric
shaft.
Standard rotor bearing oil clearance
0.06—0.08 mm {0.0024—0.0030 in}
Maximum rotor bearing oil clearance
0.1 mm {0.0039 in}
End Of Sie
APEX SEAL SPRING (LONG)
CHU0110E064
NOT MEASURED
MEASUREMENT
LOCATION
ROTOR JOURNAL (SIDE VIEW)
CHU0110E071
BHJ0110E062
ECCENTRIC SHAFT
ROTOR BEARING
ROTOR
CHU0110E017
Seitenansicht 36
1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 70 71

Kommentare zu diesen Handbüchern

Keine Kommentare