Mazda 2003 MPV Bedienungsanleitung PDF herunterladen (Seite 12)

MA13

Mazda ReferenceMA000

4. Start the engine and let it run at idle for at least 10 seconds, then switch the ignition off

5. Allow the vehicle to sit as is for at least 5 hours.

6. Start the engine and run it at 2500 RPM until it is completely warmed up. Then, run at idle

for at least 15 minutes.

7. Drive the vehicle at speeds between 40 and 50 MPH (65 to 80 KPH) for at least 5 minutes.

8. Stop the vehicle, switch the key off.

9. Allow the vehicle to sit as is for at least 20 minutes.

10. Start the engine, then access the OBD-II Readiness Monitor with the scan tool to inspect

the completion status. If not completed, turn the ignition key off and go back to Step 1.

11. Verify that no DTCs have been set.

MODE 1—Standard Drive Mode

This mode applies to the following models:

• 1996–97 626/MX6 with 2.0L engine and automatic transmission

• 1998–2002 626 with 2.0L or 2.5L engine

z To perform this Mode 1 standard drive cycle:

1. Cold soak the vehicle for at least 8 hours before performing the EVAP test.

NOTE:

i When the 8-hour timer bypass procedure is performed, the cold soak period can be shortened

up to 3 hours depending on vehicle conditions. If you shorten the soak period, the PCM may

detect a malfunction by mistake even though the EVAP system has been repaired correctly.

This misdiagnosis will happen more often under warm or hot ambient temperature. If you are

not sure whether the system still has a malfunction, cold soak 8 hours and perform the drive

mode again. If malfunction is not detected, the repair is completed.

2. Turn off all accessory loads (A/C, headlights, blower fan, etc.)

3. Drive vehicle as indicated by the graph (Figure MA000-17).

Figure MA000-17

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 48 49

Keine Kommentare

Mazda 2003 MPV Bedienungsanleitung Seite 12