Mazda 2003 MPV Bedienungsanleitung PDF herunterladen (Seite 14)

MA15

Mazda ReferenceMA000

z To perform this Mode 3 HO2S and catalyst drive cycle:

1. Verify the following conditions are met:

– The IAT sensor must be below 170°F (76°C) to initiate the monitor.

– The fuel level must be above 1/4 full to initiate the monitor.

– Monitor implement waiting condition begins 5 minutes after engine start.

– After monitor conditions are set, testing requires at least 30 seconds to complete.

2. Warm vehicle up and verify that the ECT is 175°F to 240°F (80°C to115°C).

3. Drive vehicle according to the graph (Figure MA000-19).

4. Stop vehicle and access the OBD-II Readiness Monitor with the scan tool to inspect the

completion status.

5. If not completed, turn the ignition key to OFF and repeat Steps 1 through 3.

6. Verify that no DTCs have been set.

Figure MA000-19

MODE 4—EVAP System Repair Verification Drive Mode

This mode applies to the following models:

• 1996–97 626/MX6 with 2.0L engine and automatic transmission

• 1998–2002 626 with 2.0L or 2.5L engine

z To perform this Mode 4 EVAP drive cycle:

NOTE:

i Cold soak vehicle for at least 8 hours.

1. Verify the following conditions are met:

– The IAT sensor must be within 20°F to 100°F (–7°C to 38°C) to initiate the EVAP

system monitor.

– The fuel level must be 1/4 to 3/4 full with 3/4 full being the most desirable.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 48 49

Keine Kommentare

Mazda 2003 MPV Bedienungsanleitung Seite 14